- #Retropi 2.3 emulator reset how to
- #Retropi 2.3 emulator reset driver
- #Retropi 2.3 emulator reset software
The low level specification of the controllers was already reverse engineered a long time ago. This will protect the Pi if the GPIO mode for the pin is accidentally set to output.Īn open switch without a resistor basically short circuit the GPIO if it is setup wrong.Ĭonnecting the Original Controllers and Using the Power LEDįor the perfect retro feeling I also want to reuse the original controllers.
#Retropi 2.3 emulator reset how to
This is basically the simplest thing that you can connect to the Pi and there are tons of tutorials out there on how to do that.Īfter connecting the switches, their state can be read by the Pi.įor safety reasons, I also inserted a 10 kOhm resistor in-between the wires to the GPIO. These can be connected to the Raspberry Pi's GPIO. The power button is a toggle switch while the reset button is a momentary switch.
The power as well as the reset button are simple switches as you can get them in any electronics store. Since I do not have any need for game cartriges, I simply got rid of all these parts and glued the eject button from the inside, so it doesn't hang loose. Power, reset and the cartrige eject button.Įjecting the cartrige from the Super Nintendo is solved purely mechanical with the big white plastic I took out earlier. The Super Nintendo has 3 buttons at the front. I have no idea where I got that from but it fitted perfectly into the hole for the original A/V connector. I use an USB-C cable for power and an HDMI cable for Video and Audio.Īs a convenient extra, I also exposed an USB port with a rather strange extension plug that I had lying around. To keep things simple and reduce connectors, I opted for cables directly coming out of the Super Nintendos case.
#Retropi 2.3 emulator reset software
It is reasonably cheap and the available resources and software on the internet are endless. To replace most of these parts, I bought a Raspberry Pi 4.Ĭhoosing the Raspberry Pi (again) for this project is really a no brainer. Opening up and disassembling the parts went rather smoothly. Luckily it was bit cheaper on Japanese Amazon (3-4$).
#Retropi 2.3 emulator reset driver
The Super Nintendo uses its own kind of screws and I had to buy a special screw driver just to be able to open up the case. On the downside, I had to carry it with me for the whole remaining day.īut thats a small price to pay for the "awesome" that is going to follow. The Obasan was really surprised that I wanted to buy it and was thanking me repeatedly after I handed over the 1000 Yen bill. It just costed me 1000 Yen (less than 10$)! Some Obasan (middle aged lady) along the way was having a garage sale.Īnd there it was: The original Super Famicon (Japanese Super Nintendo) from 1990. The other day I was on holiday in Otaru, Hokkaido. I guess that is what you get when you spend too much time with your handheld console but not enough time with your homework.Īnyway, here is my attempt of creating a "console" that surpasses the original in many ways. I had a Game Boy but my parents never allowed me to have a Super Nintendo. Ok, this is a project that probably has been done many times already, but I needed to do this to resolve a little childhood trauma. Lukas' Blog - The Super Nintendo RetroPie Casemod ← Home About Subscribe The Super Nintendo RetroPie Casemod August 17, 2020